User Manual

Chapter 4 - Operation and Administration Using the CLI Managing ODUs
4Motion 488 System Manual
 Reserved (refer to Section 4.6.1.2.2)
4.6.1.2.1 Configuring General ODU Parameters
The general table enables configuring the main properties of the required ODU.
To configure the general ODU parameters, run the following command:
npu(config-odu-params-1)# odu-general [heater-existence {TRUE | FALSE} ]
[external-cavity-filter-existence {TRUE | FALSE} ] [required-odu-type
{oDU23002360000N361by1N0 | oDU24962602000N361by1N0 |
oDU25902690000N361by1N0 | oDU24962602000N382by1N0 |
oDU25902690000N382by1N0 | oDU34003455000N341by1N0 |
oDU34453500000N341by1N0 | oDU35003555000N341by1N0 |
oDU35453600000N341by1N0 | oDU24962602000N384by2N0 |
oDU25902690000N384by2N0 | oDU34003600000N372by1N0 |
oDU36003800000N372by1N0 | oDU34003600000N374by2N0 |
oDU36003800000N374by2N0 | oDU23052360000N361by1Y0 |
oDU24962602000N392by1N0 | oDU25902690000N392by1N0 |
oDU24962602000N394by2N0 | oDU25902690000N394by2N0} ]
NOTE
You can display configuration information for the ODU general parameters. For details, refer to
Section 4.6.1.6.1.
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer the syntax
description for more information about the appropriate values and format for configuring these
parameters.
Command
Syntax
npu(config-odu-params-1)# odu-general [heater-existence {TRUE |
FALSE} ] [external-cavity-filter-existence {TRUE | FALSE} ]
[required-odu-type {oDU23002360000N361by1N0 |
oDU24962602000N361by1N0 | oDU25902690000N361by1N0 |
oDU24962602000N382by1N0 | oDU25902690000N382by1N0 |
oDU34003455000N341by1N0 | oDU34453500000N341by1N0 |
oDU35003555000N341by1N0 | oDU35453600000N341by1N0 |
oDU24962602000N384by2N0 | oDU25902690000N384by2N0 |
oDU34003600000N372by1N0 | oDU36003800000N372by1N0 |
oDU34003600000N374by2N0 | oDU36003800000N374by2N0 |
oDU23052360000N361by1Y0 | oDU24962602000N392by1N0 |
oDU25902690000N392by1N0 | oDU24962602000N394by2N0 |
oDU25902690000N394by2N0} ]