User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 549 System Manual
2 You can now execute any of the following tasks:
» Configure one or more of the Power Control parameters tables (refer to
Section 4.8.6.2)
» Restore the default values of parameters in one or more of the Power
Control parameters tables (refer to Section 4.8.6.3)
» Terminate the Power Control configuration mode (refer to Section 4.8.6.4)
In addition, you can, at any time, display configuration information for each of the
parameters tables (refer to Section 4.8.6.5).
4.8.6.1 Enabling the Power Control Configuration Mode
To configure the Power Control parameters, first enable the Power Control
configuration mode. Run the following command to enable the Power Control
configuration mode.
Note that for properly completing the configuration the apply command must be
executed prior to exiting the Power Control configuration mode.
npu(config-bs-66053)# pwrctrl
The Power Control configuration mode is enabled, after which you can execute
any of the following tasks:
 Configure one or more of the Power Control parameters tables (refer to
Section 4.8.6.2)
 Restore the default values of parameters in one or more of the parameters
tables (refer to Section 4.8.6.3)
After executing the above tasks, you can terminate the Power Control
configuration mode (refer to Section 4.8.6.4) and return to the BS configuration
mode.
Note that for properly completing the Power Control configuration the apply
command must be executed prior to exiting the Power Control configuration
mode.
Command
Syntax
npu(config-bs-66053)# pwrctrl