User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 547 System Manual
4.8.5.6.5 Displaying Configuration Information for All Service Mapping Profile
Parameters
To display all configuration parameters of a specific or all Service Mapping Rules,
run the following command:
npu# show srvcmaprule-all bs [<(1 to 16777215 StepSize 1)> rule-index <(1 to
255 StepSize 1)>]
Specify the BS ID and Service Mapping Rule index if you want to display
configuration for a particular Service Mapping Rule. For example, to display all
parameters of Service Mapping Rule 1 in BS 66053, run the following command:
npu# show srvcmaprule-all bs 66053 rule-index 1
Do not specify these parameters if you want to view configuration information for
all existing Service Mapping Rules. To display information for all Service Mapping
Rules, run the following command:
npu# show srvcmaprule-all bs
rule-index <(1 to 255
StepSize 1)>]
The Service Mapping Rule
index. To be used only if you
want to display the R6 Profile
parameters of a specific
Service Mapping Rule.
Optional N/A 1-255
Display
Format
(for each
existing
Service
Mapping
Rule if
requested
for all
Service
Mapping
Rules)
BSIDLSB :<value>
MappingRuleIndex :<value>
DataDeliveryTypeR6Profile :<value>
PriorityR6Profile :<value>
MediaFlowType :<value>
UseMediaFlowType :<value>
CIRR6Profile :<value>
MIRR6Profile :<value>
LatencyR6Profile :<value>
Command
Modes
Global command mode