User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs

4Motion 541 System Manual

4.8.5.6 Displaying Configuration Information for Service Mapping

Rules

You can display the current configuration information for the following

parameters tables:

 General (refer to Section 4.8.5.6.1)

 Order (refer to Section 4.8.5.6.2)

 R1 Profile (refer to Section 4.8.5.6.3)

 R6 Profile (refer to Section 4.8.5.6.4)

 All (refer to Section 4.8.5.6.5)

4.8.5.6.1 Displaying Configuration Information for General Service Mapping

Rule Parameters

To display configuration for the general parameters of a specific or all Service

Mapping Rules, run the following command:

npu# show srvcmaprule-general bs [<(1 to 16777215 StepSize 1)> rule-index <(1

to 255 StepSize 1)>]

Specify the BS ID and Service Mapping Rule index if you want to display

configuration for a particular Service Mapping Rule. For example, to display the

General parameters of Service Mapping Rule 1 in BS 66053, run the following

command:

npu# show srvcmaprule-general bs 66053 rule-index 1

Do not specify these parameters if you want to view configuration information for

all existing Service Mapping Rules. To display information for all Service Mapping

Rules, run the following command:

npu# show srvcmaprule-general bs

Command

Syntax

npu# show srvcmaprule-general bs [<(1 to 16777215 StepSize 1)> rule-index <(1 to 255

StepSize 1)> ]

Privilege

Level