User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 539 System Manual
4.8.5.3.2 Restoring the Default Values of R6 Profile Parameters
To restore some or all of R6 Profile parameters to their default values, run the
following command:
npu(config-bs-66053-srvcmaprule-1)# no r6prof [datadeliverytype ]
[priority ] [mediaflowtype ] [use-mediaflowtype] [mir ] [cir ]
[latency ]
You can restore only one or several parameters to the default values by specifying
only those parameters. For example, to restore only the mir and cir to the default
values, run the following command:
npu(config-bs-66053-srvcmaprule-1)# no r6prof mir cir
These parameter will be restored to their default values, while all other
parameters will remain unchanged.
To restore all R6 Profile parameters to their default value, run the following
command:
npu(config-bs-66053-srvcmaprule-1)# no r6prof
4.8.5.4 Terminating the Service Mapping Rule Configuration Mode
Run the following command to terminate the Service Mapping Rule configuration
mode:
Command
Modes
bs service mapping rule configuration mode
NOTE
Refer to Section 4.8.5.2.4 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-srvcmaprule-1)# no r6prof [datadeliverytype ]
[priority ] [mediaflowtype ] [use-mediaflowtype] [mir ] [cir ]
[latency ]
Privilege
Level
10
Command
Modes
bs service mapping rule configuration mode