User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 538 System Manual
4.8.5.3 Restoring Default Values for Service Mapping Rule
Configuration Parameters
After enabling the Service Mapping Rule configuration mode you can restore the
default values for non-mandatory parameters in the following parameters tables:
 R1 Profile (refer to Section 4.8.5.3.1)
 R6 Profile (refer to Section 4.8.5.3.2)
4.8.5.3.1 Restoring the Default Values of RI Profile Parameters
To restore some or all of R1 Profile non-mandatory parameters to their default
values, run the following command:
npu(config-bs-66053-srvcmaprule-1)# no r1prof [modify-serviceqos ]
[dfltpriority ]
You can restore only one or several parameters to the default values by specifying
only those parameters. For example, to restore only the dfltpriority to the default
value, run the following command:
npu(config-bs-66053-srvcmaprule-1)# no r1prof dfltpriority
The parameter will be restored to its default value, while the other parameters will
remain unchanged.
To restore all R1 Profile non-mandatory parameters to their default value, run the
following command:
npu(config-bs-66053-srvcmaprule-1)# no r1prof
Command
Modes
bs service mapping rule configuration mode
NOTE
Refer to Section 4.8.5.2.3 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-srvcmaprule-1)# no r1prof [modify-serviceqos ]
[dfltpriority ]
Privilege
Level
10