User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 536 System Manual
4.8.5.2.4 Configuring R6 Profile Parameters
To configure mapping rules to R6 Profile parameters, run the following command:
npu(config-bs-66053-srvcmaprule-1)# r6prof [datadeliverytype {uGS |
rTVR | nRTVR | bE | eRTVR | any} ] [priority <(-1 to -1 StepSize 1) | (0 to 7
StepSize 1)> ] [mediaflowtype <string (32)> ] [use-mediaflowtype {TRUE | FALSE} ]
[mir <(-1 to -1 StepSize 1) | (0 to 20000 StepSize 1)> ] [cir <(-1 to -1 StepSize 1) |
(0 to 20000 StepSize 1)> ] [latency <(-1 to -1 StepSize 1) | (0 to 5000 StepSize 1)>].
IMPORTANT
Note that when creating a new Service Mapping Rule all mandatory parameters must be
configured, including those that may not be relevant for the Service Mapping Rule.
IMPORTANT
When creating a new Service Mapping Rule, at least one of the R6 Profile parameters must be
configured explicitly (even if configured to the default value).
Command
Syntax
npu(config-bs-66053-srvcmaprule-2)# r6prof [datadeliverytype {uGS
| rTVR | nRTVR | bE | eRTVR | any} ] [priority <(-1 to -1 StepSize
1) | (0 to 7 StepSize 1)> ] [mediaflowtype <string (32)> ]
[use-mediaflowtype {TRUE | FALSE} ] [mir <(-1 to -1 StepSize 1) |
(0 to 20000 StepSize 1)> ] [cir <(-1 to -1 StepSize 1) | (0 to
20000 StepSize 1)> ] [latency <(-1 to -1 StepSize 1) | (0 to 5000
StepSize 1)> ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values