User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 532 System Manual
4.8.5.2.2 Configuring the Order Parameters
The Order Parameters table enables configuring the look-up-order parameter that
defines the order in which conceptual rows of the table are checked to find a
match.
To configure the Order parameters, run the following command:
npu(config-bs-66053-srvcmaprule-1)# order look-up-order <(1 to 255
StepSize 1)>
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[srvc <string (32)> ] The service type to which the
connection will be mapped.
Must be the same as the
name (type) configured for
the relevant service (refer to
Section 4.8.4).
All service a certain data
delivery type (see
Section 4.8.5.2.3) must
use the same service type
(same HARQ properties).
Mandatory A string of 1
to 32 printable
characters.
Command
Modes
bs service mapping rule configuration mode
IMPORTANT
When creating a new Service Mapping Rule, the mandaory order parameter must be configured.
Command
Syntax
npu(config-bs-66053-srvcmaprule-1)# order [look-up-order <(1 to
255 StepSize 1)> ]
Privilege
Level
10