User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 531 System Manual
4.8.5.2 Configuring Service Mapping Rule Parameters
After enabling the Service Mapping Rule configuration mode you can configure the
following parameters tables:
 General (refer to Section 4.8.5.2.1)
 Order (refer to Section 4.8.5.2.2)
 R1 Profile (refer to Section 4.8.5.2.3)
 R6 Profile (refer to Section 4.8.5.2.4)
4.8.5.2.1 Configuring General Service Mapping Rule Parameters
The General Service Mapping Parameters table enables associating the Service
Mapping Rule to a specific Service.
To configure the General Service Mapping Rule parameters, run the following
command:
npu(config-bs-66053-srvcmaprule-1)# general srvc <string (32)>
NOTE
The following examples are for BS Service Mapping Rule configuration mode for bs-66053, service
mapping rule (srvcmaprule)-1.
IMPORTANT
After completing the Service Mapping Rule configuration,do not forget to execute the apply
command before exiting the BS Service Mapping Rule configuration mode:
npu(config-bs-66053-srvcmaprule-1)# apply
IMPORTANT
When creating a new Service Mapping Rule, the mandatory srvc parameters must be configured.
Command
Syntax
npu(config-bs-66053-srvcmaprule-1)# general srvc <string (32)>
Privilege
Level
10