User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 524 System Manual
If you use this command to create a new service, the configuration mode for this
service is automatically enabled, after which you can execute any of the following
tasks:
 Configure the parameters of the service (refer to Section 4.8.4.2)
 Restore the default values for the non-mandatory parameters of the service
(refer to Section 4.8.4.3)
After executing the above tasks, you can terminate the BS Service configuration
mode (refer to Section 4.8.4.4) and return to the BS configuration mode. From the
BS configuration mode you can delete an existing service (refer to Section 4.8.4.5).
You can display configuration information for BS services from the global
command mode (refer to Section 4.8.4.6).
Note that for properly completing the configuration of a service the apply
command must be executed prior to exiting the BS Service configuration mode.
4.8.4.2 Configuring Service Parameters
From the BS configuration mode, run the following command:
npu(config-bs-66053-service-video)# def [max-dl-rtx <(0 to 15
StepSize1)> ] [max-ul-rtx <(0 to 15 StepSize 1)> ] [max-subburst
Command
Syntax
npu(config-bs-66053)# service <(string (32))>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(string (32))> The Service name (type). Mandatory N/A A string of 1 to
32 characters.
Command
Modes
bs configuration mode
To configure the BS Service Parameters: