User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 522 System Manual
npu(config-bs-66053)# no general operator-id
The operator-id will be restored to its default value, while the bs-name parameter
will remain unchanged.
To restore all parameters to their default value, run the following command:
npu(config-bs-66053)# no general
4.8.3.3 Displaying Configuration Information for BS General
Parameters
To display configuration information of the general parameters of a specific or all
BSs, run the following command:
npu# show general bs [<(1 to 16777215 StepSize 1)>]
Specify the BS ID (1-16777215) of an existing BS if you want to display
configuration information for a particular BS. Do not specify values for this
parameter if you want to view configuration information for all existing BSs.
NOTE
Refer to Section 4.8.3.1 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053)# no general [operator-id] [bs-name]
Privilege
Level
10
Command
Modes
bs configuration mode
Command
Syntax
npu# show general bs [<(1 to 16777215 StepSize 1)> ]
Privilege
Level
1