User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 521 System Manual
4.8.3.2 Restoring Default Values for BS General Parameters
After enabling the BS configuration mode you can restore the default values for
one or all of the general BS parameters.
To restore one or all general BS parameters do their default value, run the
following command:
npu(config-bs-66053)# no general [operator-id] [bs-name]
You can restore one parameter to its default value by specifying only that
parameter. For example, to restore only the operator-id to its default value, run
the following command:
IMPORTANT
When creating a new BS, at least one of the BS General parameters must be configured explicitly
(even if configured to the default value).
Command
Syntax
npu(config-bs-66053)# general [operator-id <(1 to 16777215
StepSize 1)> ] [bs-name <string (32)> ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[operator-id <(1 to
16777215 StepSize 1)>]
A unique operator
identifier. The same
Operator ID must be
used throughout the
radio access network.
(a 24-bit value that
can be represented as
A.B.C where A, B, C
are from 0 to 255)
Optional 16773929 1 to 16777215
[bs-name <string (32)>] BS name Optional empty
string
A string of up to
32 printable
characters.
Command
Modes
bs configuration mode