User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 518 System Manual
4.8.1 Enabling the BS Configuration Mode\Creating
a BS Object
To configure the parameters of a BU, first enable the BS configuration mode for
the specific BS. Run the following command to enable the BS configuration mode.
You can also use this command to create a new BS object. Note that for a new
object this command only defines the BS ID, and that the BS is not fully created
until completing configuration of all mandatory parameters.
The BS ID is the unique identifier of the BS in the access network. The BS ID used
in the system is in the format A.B.C where A, B, C are from 0 to 255. The BS ID
used in the CLI is an integer that is calculated by the formula A*65536+B*256+C.
For example, a BS ID of 1.2.5 is translated to 1*65536+2*256+5=66053.
npu(config)# bs <(1 to 16777215 StepSize 1)>
For example, to configure BS 66053, run the following command:
npu (config)# bs 66053
If you use this command to create a new BS, the configuration mode for this BS is
automatically enabled, after which you can execute any of the following tasks:
 Configure one or more of the parameters tables of the BS
“Managing BS Management Alarm
Thresholds Parameters” on page 721
No
“Managing ID-IP Mapping Parameters”
on page 724
nw-node-id (Next Hop BS ID)
nw-node-ip
No
“Managing Ranging Parameters” on
page 728
Yes
“Managing Alarm Threshold Parameters”
on page 750
No
“Managing BS Reserved Parameters” on
page 756
No
“Managing the BS Keep-Alive
Functionality” on page 760
No
IMPORTANT
An error occurs if you specify BS ID that is not in the range, 1-16777215.
Table 4-29: Tasks for Configuring a BS
Task Mandatory Parameters apply required