User Manual

Chapter 4 - Operation and Administration Using the CLI Managing ODUs
4Motion 484 System Manual
To create a new ODU object, the mandatory required-odu-type parameter must be
specified. Run the following command to create a new ODU object and enable the
parameters configuration mode for this ODU:
npu (config)# odu-params <(1 to 28 StepSize 1)> required-odu-type
{oDU23002360000N361by1N0 | oDU24962602000N361by1N0 |
oDU25902690000N361by1N0 | oDU24962602000N382by1N0 |
oDU25902690000N382by1N0 | oDU34003455000N341by1N0 |
oDU34453500000N341by1N0 | oDU35003555000N341by1N0 |
oDU35453600000N341by1N0 | oDU24962602000N384by2N0 |
oDU25902690000N384by2N0 | oDU34003600000N372by1N0 |
oDU36003800000N372by1N0 | oDU34003600000N374by2N0 |
oDU36003800000N374by2N0 | oDU23052360000N361by1Y0 |
oDU24962602000N392by1N0 | oDU25902690000N392by1N0 |
oDU24962602000N394by2N0 | oDU25902690000N394by2N0}
A new ODU object is created with default values for all parameters except to the
mandatory required-odu-type parameter.
For example, to create an ODU 1 object and enable the parameters configuration
mode for this ODU, where the required odu type is oDU23002360000N361by1N0,
run the following command:
npu (config)# odu-params 1 required-odu-type oDU23002360000N361by1N0
After enabling the parameters configuration mode for an ODU you can execute
any of the following tasks:
 Configure one or more of the parameters tables of the ODU (refer to
Section 4.6.1.2)
 Restore the default values of parameters in one or more of the parameters
tables of the ODU (refer to Section 4.6.1.3)
After executing the above tasks, you can terminate the ODU parameters
configuration mode (refer to Section 4.6.1.4) and return to the global
configuration mode.
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer the syntax
description for more information about the appropriate values and format for configuring these
parameters.