User Manual

Chapter 4 - Operation and Administration Using the CLI Managing Antennas
4Motion 510 System Manual
You can restore one or several parameters to the default value(s) by specifying
only those parameter. For example, to restore only the mechanical-downtilt and
electrical-downtilt to their default values, run the following command:
npu(config-antenna-1)# no params mechanical-downtilt
electrical-downtil
The mechanical-downtilt and electrical-downtilt will be restored to their default
values, while all other parameters will remain unchanged.
To restore all parameters to their default value, run the following command:
npu(config-antenna-1)# no params
4.7.4 Terminating the Antenna Configuration Mode
Run the following command to terminate the Antenna configuration mode:
npu(config-antenna-1)# exit
NOTE
Refer to Section 4.7.2 for a description and default values of these parameters.
Command
Syntax
npu(config-antenna-1)# no params [antenna-type] [no-of-ports]
[gain] [mechanical-downtilt] [electrical-downtil]
[electrical-azimuth-adjustment] [longitude] [latitude]
[tower-height] [altitude] [beamwidth] [cable-loss]
Privilege
Level
10
Command
Modes
antenna configuration mode
Command
Syntax
npu(config-antenna-1)# exit
Privilege
Level
10