User Manual

Chapter 4 - Operation and Administration Using the CLI Managing Antennas
4Motion 509 System Manual
4.7.3 Restoring Default Values for Antenna
Parameters
After enabling the Antenna configuration mode you can restore the default values
for some or all of the parameters (excluding the mandatory heading parameter).
To restore one or several Antenna parameters do their default value, run the
following command:
npu(config-antenna-1)# no params [antenna-type] [no-of-ports]
[gain] [mechanical-downtilt] [electrical-downtil]
[electrical-azimuth-adjustment] [longitude] [latitude]
[tower-height] [altitude] [beamwidth] [cable-loss]
[altitude <(-500 to
10000 StepSize
1)> ]
Absolute altitude of the
sector (above sea level) in
meters.
Optional -500 to 10000
[heading <(0 to
359 StepSize 1)> ]
Indicates the azimuth angle
(in degrees) between the
center of the horizontal
antenna beamwidth and the
true north; counting
clockwise.
Optional 0-359
[beamwidth <(0 to
359 StepSize 1)> ]
Beamwidth of the antenna in
degrees
Optional 60 0-359
[cable-loss <(0 to
20 StepSize 0.1)> ]
The attenuation (in dB) of the
cable between the ODU port
and antenna port (informative
only)
Optional 0.5 0-20 in steps of
0.1
Command
Modes
antenna configuration mode
NOTE
You can display configuration information for the Antenna parameters. For details, refer to
Section 4.7.6.
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer the syntax
description for more information about the appropriate values and format for configuring these
parameters.