User Manual

Chapter 4 - Operation and Administration Using the CLI Managing Antennas
4Motion 507 System Manual
4.7.2 Configuring Antenna Parameters
After enabling the Antenna configuration mode you can configure the Antenna
parameters.
To configure the Antenna parameters, run the following command:
npu(config-antenna-1)# params [antenna-type <string (32)>] [no-of-ports <(1 to 8
StepSize 1)>] [gain <(0 to 60 StepSize 0.1)>] [mechanical-downtilt <(-90 to 90
StepSize 0.1)>] [electrical-downtilt <(-90 to 90 StepSize 0.2)>]
[electrical-azimuth-adjustment <(-90 to 90 StepSize 0.3)>] [longitude <longitude>]
[latitude <latitude>] [tower-height <(0 to 500 StepSize 1)>] [altitude <(-500 to
10000 StepSize 1)>] [heading <(0 to 359 StepSize 1)>] [beamwidth <(0 to 359
StepSize 1)>] [cable-loss <(0 to 20 StepSize 0.1)>]
[heading <(0 to 359
StepSize 1)>]
Indicates the azimuth angle
(in degrees) between the
center of the horizontal
antenna beamwidth and the
true north; counting
clockwise.
Mandatory
for a new
Antenna
N/A 0 to 359
Command
Modes
Global configuration mode
NOTE
The following examples are for antenna-1 configuration mode.
Command
Syntax
npu(config-antenna-1)# params [antenna-type <string (32)> ]
[no-of-ports <(1 to 8 StepSize 1)> ] [gain <(0 to 60 StepSize
0.1)> ] [mechanical-downtilt <(-90 to 90 StepSize 0.1)> ]
[electrical-downtil <(-90 to 90 StepSize 0.2)> ]
[electrical-azimuth-adjustment <(-90 to 90 StepSize 0.3)> ]
[longitude <longitude> ] [latitude <latitude> ] [tower-height <(0
to 500 StepSize 1)> ] [altitude <(-500 to 10000 StepSize 1)> ]
[heading <(0 to 359 StepSize 1)> ] [beamwidth <(0 to 359 StepSize
1)> ] [cable-loss <(0 to 20 StepSize 0.1)> ]
Privilege
Level
10