User Manual

Chapter 4 - Operation and Administration Using the CLI Managing Antennas
4Motion 506 System Manual
For example, to create Antenna 1 with a configured heading of 90 degrees and
enable the parameters configuration mode for this Antenna, run the following
command:
npu (config)# antenna 1 heading 90
After enabling the configuration mode for an Antenna you can execute any of the
following tasks:
 Configure one or more of the parameters of the Antenna (refer to Section 4.7.2)
 Restore the default value of the non-mandatory parameters parameter (refer to
Section 4.7.3)
After executing the above tasks, you can terminate the Antenna configuration
mode (refer to Section 4.7.4) and return to the global configuration mode.
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer the syntax
description for more information about the appropriate values and format for configuring these
parameters.
CAUTION
When an antenna is associated to a sector, the antenna heading must be the same as the sector
heading for every antenna associated to the sector.
Command
Syntax
npu (config)# antenna <(1 to 28 StepSize 1)> [heading <(0 to 359 StepSize 1)>]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 28 StepSize 1)> The ODU number Mandatory N/A 1-28