User Manual

Chapter 4 - Operation and Administration Using the CLI Managing Antennas
4Motion 505 System Manual
4.7 Managing Antennas
Up to 28 Antenna objects, identified by the Antenna number (1-28), can be
created and configured.
1 Enable the Antenna configuration mode for the selected Antenna (refer to
Section 4.7.1)
2 You can now execute any of the following tasks:
» Configure one or more of the Antenna parameters (Section 4.7.2)
» Restore the default value of some or all of the Antenna parameters (refer to
Section 4.7.3)
3 Terminate the Antenna configuration mode (refer to Section 4.7.4)
In addition, you can, at any time, display configuration information for one or all
of the Antennas (refer to Section 4.7.6) or delete an existing Antenna (refer to
Section 4.7.5).
4.7.1 Enabling the Antenna Configuration
Mode\Creating an Antenna
To configure the parameters of an Antenna, first enable the Antenna configuration
mode for the specific Antenna. Run the following command to enable the Antenna
configuration mode for an existing Antenna:
npu (config)# antenna <(1 to 28 StepSize 1)>
To create a new Antenna, the mandatory heading parameter must be specified.
Run the following command to create a new Antenna and enable the configuration
mode for this Antenna:
npu (config)# antenna <(1 to 28 StepSize 1)> heading <(0 to 359 StepSize 1)>
A new Antenna is created with default values for all other parameters.
To configure an Antenna: