User Manual
Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 681 System Manual
4.8.19.5.11 Displaying Configuration Information for Airframe Dynamic
Permutation Parameters
To display configuration for the Airframe Dynamic Permutation parameters, run
the following command:
npu# show airframe-dynamicperm bs [<(1 to 16777215 StepSize 1)>]
Specify the BS ID if you want to display configuration for a particular BS. For
example, to display the Airframe Dynamic Permutation parameters of BS 66503,
run the following command:
npu# show airframe-dynamicperm bs 66053
Do not specify the BS ID if you want to view configuration information for all
existing BSs. To display information for all BSs, run the following command:
npu# show airframe-dynamicperm bs
Display
Format
(for each
existing
Neighbour
BS in each
of the
existing BSs
if requested
for all)
BSIDLSB :<value>
ULDATAPermutationBase :<value>
StartAllocation(Slots) :<value>
ULDATAZoneNumberofSub-Channels :<value>
Command
Modes
Global command mode
Command
Syntax
npu# show airframe-dynamicperm bs [<(1 to 16777215 StepSize 1)> ]
Privilege
Level
1