User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 678 System Manual
4.8.19.5.9 Displaying Configuration Information for Airframe Downlink Data Zone
Parameters
To display configuration for the Airframe Downlink Data Zone parameters, run
the following command:
npu# show airframe-dldatazone bs [<(1 to 16777215 StepSize 1)>]
Command
Syntax
npu# show airframe-ulfeedbackzone bs [<(1 to 16777215 StepSize 1)> ]
Privilege
Level
1
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 16777215
StepSize 1)>
The BS ID
Specify a value for this
parameter if you want to
display the Airframe Uplink
Feedback Zone parameters
of a specific BS. Do not
specify a value for this
parameter if you want to
display the Airframe Uplink
Feedback Zone parameters
of all BSs.
Optional N/A 1-16777215
Display
Format
(for each
existing
Neighbour
BS in each
of the
existing BSs
if requested
for all)
BSIDLSB :<value>
ULFeedbackZoneNumberofSub-Channels :<value>
ULFeedbackZonePermutationBase :<value>
Command
Modes
Global command mode