User Manual

Chapter 4 - Operation and Administration Using the CLI Managing ODUs
4Motion 500 System Manual
4.6.2.3 Restoring Default Values for ODU Port Parameters
After enabling the ODU Port configuration mode you can restore the default
values for the txpower-onoff parameter:
To restore the default values for the txpower-onoff parameter, run the following
command:
npu(config-odu-port-1-1)# no params
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer the syntax
description for more information about the appropriate values and format for configuring these
parameters.
Command
Syntax
npu(config-odu-port-1-1)# params [txpower <(0 to 46 StepSize
0.1)>] [txpower-onoff {on | off} ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[txpower <(0 to 46
StepSize 0.1)>]
The transmit power at the
ODU Port, in dBm.
Optional As
configured
previouslu
0 to 46 in
increments of 0.1
Actual range
depends on ODU
type.
[txpower-onoff {on
| off} ]
Enables or disables
transmissions on this port.
Optional on
 on
 off
Command
Modes
odu-port configuration mode
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer the syntax
description for more information about the appropriate values and format for configuring these
parameters.