User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 668 System Manual
4.8.19.5 Displaying Configuration Information for Airframe
Parameters
You can display the current configuration information for the following Airframe
parameters tables:
 General (refer to Section 4.8.19.5.1)
 Map Zone (refer to Section 4.8.19.5.2)
 Downlink Diversity (refer to Section 4.8.19.5.3)
 Cyclic Delay (refer to Section 4.8.19.5.4)
 Linear Delay (refer to Section 4.8.19.5.5)
 Mapping (refer to Section 4.8.19.5.6)
 Receive (refer to Section 4.8.19.5.7)
 Uplink Feedback Zone (refer to Section 4.8.19.5.8)
 Downlink Data Zone (refer to Section 4.8.19.5.9)
 Uplink Data Zone (refer to Section 4.8.19.5.10)
 Dynamic Permutation (refer to Section 4.8.19.5.11)
 All (refer to Section 4.8.19.5.12)
4.8.19.5.1 Displaying Configuration Information for Airframe General Parameters
To display configuration for the Airframe General parameters, run the following
command:
npu# show airframe-general bs [<(1 to 16777215 StepSize 1)>]
Privilege
Level
10
Command
Modes
bs airframe configuration mode