User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 667 System Manual
npu(config-bs-66053-airframe)# no dynamicperm [dl-permbase] [ul-permbase]
You can restore only one parameter to the default value by specifying only that
parameter. For example, to restore only the dl-permbase to the default value, run
the following command:
npu(config-bs-66053-airframe)# no dynamicperm dl-permbase
The parameter will be restored to its default value, while the other parameter will
remain unchanged.
To restore all non-mandatory parameters to their default value, run the following
command:
npu(config-bs-66053-airframe)# no dynamicperm
4.8.19.4 Terminating the Airframe Configuration Mode
Run the following command to terminate the Airframe configuration mode:
npu(config-bs-66053-airframe)# exit
NOTE
Refer to Section 4.8.19.2.11 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-airframe)# no dynamicperm [dl-permbase ]
[ul-permbase ]
Privilege
Level
10
Command
Modes
bs airframe configuration mode
IMPORTANT
Do not forget to execute the apply command before terminating the Airframe configuration mode:
npu(config-bs-66053-airframe)# apply
Command
Syntax
npu(config-bs-66053-airframe)# exit