User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 665 System Manual
You can restore only one or several parameters to the default values by specifying
only those parameters. For example, to restore only the adminchannel-1 and
adminchannel-2 parameters to the default value, run the following command:
npu(config-bs-66053-airframe)# no rx adminchannel-1 adminchannel-2
These parameters will be restored to their default values, while the other
parameters will remain unchanged.
To restore all parameters to their default value, run the following command:
npu(config-bs-66053-airframe)# no rx
4.8.19.3.8 Restoring the Default Value of Airframe Uplink Feedback Zone
Subchannels Parameter
To restore the Airframe Uplink Feedback Zone non-mandatory subchannels
parameter to its default value, run the following command:
npu(config-bs-66053-airframe)# no ulfeedbackzone subchannels
Since the Downlink Diversity table contains a single non-mandatory parameter, it
is sufficient to run the following command:
npu(config-bs-66053-airframe)# no ulfeedbackzone
NOTE
Refer to Section 4.8.19.2.7 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-airframe)# no rx [adminchannel-1 ]
[adminchannel-2 ] [adminchannel-3 ] [adminchannel-4 ]
Privilege
Level
10
Command
Modes
bs airframe configuration mode
NOTE
Refer to Section 4.8.19.2.8 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-airframe)# no ulfeedbackzone [subchannels ]