User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 664 System Manual
4.8.19.3.6 Restoring the Default Values of Airframe Mapping Parameters
To restore one or all of the Airframe Mapping parameters to their default values,
run the following command:
npu(config-bs-66053-airframe)# no mapping [channel-1] [channel-2]
[channel-3] [channel-4]
You can restore only one or several parameters to the default values by specifying
only those parameters. For example, to restore only the channel-1 and channel-2
parameters to the default value, run the following command:
npu(config-bs-66053-airframe)# no mapping channel-1 channel-2
These parameters will be restored to their default values, while the other
parameters will remain unchanged.
To restore all parameters to their default value, run the following command:
npu(config-bs-66053-airframe)# no mapping
4.8.19.3.7 Restoring the Default Values of Airframe Receive Parameters
To restore one or all of the Airframe Receive parameters to their default values,
run the following command:
npu(config-bs-66053-airframe)# no rx [adminchannel-1] [adminchannel-2]
[adminchannel-3] [adminchannel-4]
Command
Modes
bs airframe configuration mode
NOTE
Refer to Section 4.8.19.2.6 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-airframe)# no mapping [channel-1 ] [channel-2 ]
[channel-3 ] [channel-4 ]
Privilege
Level
10
Command
Modes
bs airframe configuration mode