User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 663 System Manual
4.8.19.3.5 Restoring the Default Values of Airframe Linear Delay Parameters
To restore one or all of the Airframe Linear Delay parameters to their default
values, run the following command:
npu(config-bs-66053-airframe)# no lineardelay [channel-1] [channel-2]
[channel-3] [channel-4]
You can restore only one or several parameters to the default values by specifying
only those parameters. For example, to restore only the channel-1 and channel-2
parameters to the default value, run the following command:
npu(config-bs-66053-airframe)# no lineardelay channel-1 channel-2
These parameters will be restored to their default values, while the other
parameters will remain unchanged.
To restore all parameters to their default value, run the following command:
npu(config-bs-66053-airframe)# no lineardelay
NOTE
Refer to Section 4.8.19.2.4 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-airframe)# no cyclicdelay [channel-1 ] [channel-2
] [channel-3 ] [channel-4 ]
Privilege
Level
10
Command
Modes
bs airframe configuration mode
NOTE
Refer to Section 4.8.19.2.5 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-airframe)# no lineardelay [channel-1 ] [channel-2
] [channel-3 ] [channel-4 ]
Privilege
Level
10