User Manual

Chapter 4 - Operation and Administration Using the CLI Managing ODUs
4Motion 499 System Manual
4.6.2.2 Configuring ODU Port Parameters
After enabling the ODU Port configuration mode you can configure the transmit
power parameters of the port.
To configure the ODU Port parameters, run the following command:
npu(config-odu-port-1-1)# params [txpower <(0 to 46 StepSize 0.1)> ]
[txpower-onoff {on | off} ]
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 28 StepSize 1)> The ODU number Mandatory N/A 1-28
<(1 to 4 StepSize 1)> The Port number. Mandatory N/A 1-4
[txpower <(0 to 46
StepSize 0.1)>]
The required tx power at the
specified ODU Port, in dBm.
The actually available range
depends on ODU Type: The
upper limit is set by the
Maximum Tx Power supported
by the ODU (see
“Currently
Available Single Port
ODU Types” on
page 487
). The control range
for all ODUs is 10dBm, except
to the following ODUs whose
control range is 6dBm:
oDU23002360000N361by1N0,
oDU24962602000N361by1N0,
oDU25902690000N361by1N0,
oDU23052360000N361by1Y0
Mandatory
for a new
ODU Port
N/A 0 to 46 in
increment
s of 0.1
Command
Modes
Global configuration mode
NOTE
The following examples are for odu-1, port-1 configuration mode.
NOTE
You can display configuration information for the ODU Port parameters. For details, refer to
Section 4.6.2.6.