User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 660 System Manual
 Downlink Diversity (refer to Section 4.8.19.3.3)
 Cyclic Delay (refer to Section 4.8.19.3.4)
 Linear Delay (refer to Section 4.8.19.3.5)
 Mapping (refer to Section 4.8.19.3.6)
 Receive (refer to Section 4.8.19.3.7)
 Uplink Feedback Zone (refer to Section 4.8.19.3.8)
 Uplink Data Zone (refer to Section 4.8.19.3.9)
 Dynamic Permutation (refer to Section 4.8.19.3.10)
4.8.19.3.1 Restoring the Default Values of Airframe General Parameters
To restore one or all of the Airframe non-mandatory General parameters to their
default values, run the following command:
npu(config-bs-66053-airframe)# no general [preamble-grp]
[enable-ul-scrotation]
You can restore only one parameter to the default value by specifying only that
parameter. For example, to restore only the preamble-grp to the default value, run
the following command:
npu(config-bs-66053-airframe)# no general preamble-grp
The parameter will be restored to its default value, while the other parameter will
remain unchanged.
To restore all non-mandatory parameters to their default value, run the following
command:
npu(config-bs-66053-airframe)# no general
NOTE
Refer to Section 4.8.19.2.1 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-airframe)# no general [preamble-grp ]
[enable-ul-scrotation ]