User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 659 System Manual
4.8.19.3 Restoring Default Values for Airframe Configuration
Parameters
After enabling the Airframe configuration mode you can restore the default values
for non-mandatory parameters in the following parameters tables:
 General (refer to Section 4.8.19.3.1)
 Map Zone (refer to Section 4.8.19.3.2)
IMPORTANT
When creating a new BS, the Airframe Dynamic Permutation mandatory permbase parameter must
be configured.
Command
Syntax
npu(config-bs-66053-airframe)# dynamicperm [dl-permbase {TRUE |
FALSE} ] [ul-permbase {TRUE | FALSE} ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
dl-permbase
{TRUE | FALSE}
The Downlink Permutation
Base. If TRUE we use the
same Permutation Base
over all frames (Static). If
FALSE the Permutation
Base changes from frame
to frame (Dynamic).
Optional True
 TRUE
 FALSE
ul-permbase
{TRUE | FALSE}
The Uplink Permutation
Base. If TRUE we use the
same Permutation Base
over all frames. If FALSE
the Permutation Base
changes from frame to
frame.
Optional True
 TRUE
 FALSE
Command
Modes
bs airframe configuration mode