User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 658 System Manual
4.8.19.2.11 Configuring Airframe Dynamic Permutation Parameters
To configure the Airframe Dynamic Permutation parameters, run the following
command:
npu(config-bs-66053-airframe)# dynamicperm [dl-permbase {TRUE | FALSE}]
[ul-permbase {TRUE | FALSE}]]
IMPORTANT
When creating a new BS, the Airframe Structure Uplink Data Zone mandatory permbase parameter
must be configured.
Command
Syntax
npu(config-bs-66053-airframe)# uldatazone [permbase <(0 to 69
StepSize 1)> ] [startallocation <(0 to 209 StepSize 1)> ]
[subchannels-number <(1 to 35 StepSize 1)> ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[permbase <(0 to 69
StepSize 1)> ]
The permutation base
used in the uplink
datazone
Optional 0 to 69 in steps
of 1
[startallocation <(0 to
209 StepSize 1)> ]
The start allocation for the
uplink datazone in slots
Optional 0 0 to 209 in
steps of 1
[subchannels-number
<(1 to 35 StepSize 1)>
]
The number of
subchannels used in the
uplink datazone.
If bandwidth=7MHz or
10MHz, valid range is
1-35. If bandwidth=5MHz,
valid range is 1-17. The
default for
bandwidth=5MHz should
be 17.
Optional 35
default
value=35
(7 , 10
MHz) or
17 (5MHz)
1- 35
Command
Modes
bs airframe configuration mode