User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 657 System Manual
npu(config-bs-66053-airframe)# dldatazone [subchannels <(1 to 30 StepSize
1)>] [permbase <(0 to 31 StepSize 1)>]
4.8.19.2.10 Configuring Airframe Uplink Data Zone Parameters
To configure the Airframe Uplink Data Zone parameters, run the following
command:
npu(config-bs-66053-airframe)# uldatazone [permbase <(0 to 69 StepSize 1)>]
[startallocation <(0 to 209 StepSize 1)>] [subchannels-number <(1 to 35 StepSize
1)>]
IMPORTANT
When creating a new BS, the Airframe Uplink Feedback Zone mandatory parameters must be
configured.
Command
Syntax
npu(config-bs-66053-airframe)# dldatazone [subchannels <(1 to 30
StepSize 1)> ] [permbase <(0 to 31 StepSize 1)> ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[subchannels <(1 to
30 StepSize 1)> ]
The number of subchannels
used in thedownlink data
zone.
If bandwidth=7MHz or
10MHz, valid range is 1-30.
If bandwidth=5MHz, valid
range is 1-15.
Mandatory
when
creating a
new BS.
N/A 1-30
[permbase <(0 to 31
StepSize 1)> ]
The permutation base used
in the downlink data zone
Mandatory
when
creating a
new BS.
N/A 0 - 31
Command
Modes
bs airframe configuration mode