User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 655 System Manual
4.8.19.2.8 Configuring Airframe Uplink Feedback Zone Parameters
To configure the Airframe Uplink Feedback Zone parameters, run the following
command:
npu(config-bs-66053-airframe)# ulfeedbackzone [subchannels <(1 to 35
StepSize 1)>] [permbase <(0 to 69 StepSize 1)>]
IMPORTANT
When creating a new BS, at least one of the Airframe Receive parameters must be configured
explicitly (even if configured to the default value). configured.
Command
Syntax
npu(config-bs-66053-airframe)# rx [adminchannel-1 {TRUE | FALSE} ]
[adminchannel-2 {TRUE | FALSE} ] [adminchannel-3 {TRUE | FALSE} ]
[adminchannel-4 {TRUE | FALSE} ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[adminchannel-1
{TRUE | FALSE} ]
The desired status of
channel 1 in the modem
receiver. A value of TRUE
means enabled.
Optional TRUE
 TRUE
 FALSE
[adminchannel-2
{TRUE | FALSE} ]
The desired status of
channel 2 in the modem
receiver. A value of TRUE
means enabled.
Optional FALSE
 TRUE
 FALSE
[adminchannel-3
{TRUE | FALSE} ]
The desired status of
channel 3 in the modem
receiver. A value of TRUE
means enabled.
Optional FALSE
 TRUE
 FALSE
[adminchannel-4
{TRUE | FALSE} ]
The desired status of
channel 4 in the modem
receiver. A value of TRUE
means enabled.
Optional FALSE
 TRUE
 FALSE
Command
Modes
bs airframe configuration mode