User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 652 System Manual
4.8.19.2.6 Configuring Airframe Mapping Parameters
To configure the Airframe Mapping parameters, run the following command:
npu(config-bs-66053-airframe)# mapping [channel-1 {l1 | l1slashL2 | Silence}]
[channel-2 {l1 | l1slashL2 | Silence}] [channel-3 {l1 | l1slashL2 | Silence}]
[channel-4 {l1 | l1slashL2 | Silence}]
[channel-4 <(0 to 4
StepSize 0.01)> ]
Controls the linear delay (in
microseconds) applied to PHY
physical channel #4 of the
Downlink Data Zone.
Not relevant if dldiversity mode
(see
Section 4.8.19.2.3 is
“none”)
Optional 0 0 to 4 in steps
of 0.01
Command
Modes
bs airframe configuration mode
IMPORTANT
When creating a new BS, at least one of the Airframe Mapping parameters must be configured
explicitly (even if configured to the default value). configured.
Command
Syntax
npu(config-bs-66053-airframe)# mapping [channel-1 {l1 | l1slashL2 |
Silence} ] [channel-2 {l1 | l1slashL2 | Silence} ] [channel-3 {l1
| l1slashL2 | Silence} ] [channel-4 {l1 | l1slashL2 | Silence} ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values