User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 651 System Manual
npu(config-bs-66053-airframe)# lineardelay [channel-1 <(0 to 4 StepSize 0.01)>]
[channel-2 <(0 to 4 StepSize 0.01)>] [channel-3 <(0 to 4 StepSize 0.01)>]
[channel-4 <(0 to 4 StepSize 0.01)>]
IMPORTANT
When creating a new BS, at least one of the Airframe Linear Delay parameters must be configured
explicitly (even if configured to the default value). configured.
Command
Syntax
npu(config-bs-66053-airframe)# lineardelay [channel-1 <(0 to 4
StepSize 0.01)> ] [channel-2 <(0 to 4 StepSize 0.01)> ] [channel-3
<(0 to 4 StepSize 0.01)> ] [channel-4 <(0 to 4 StepSize 0.01)> ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[channel-1 <(0 to 4
StepSize 0.01)> ]
Controls the linear delay (in
microseconds) applied to PHY
physical channel #1 of the
Downlink Data Zone.
Not relevant if dldiversity mode
(see
Section 4.8.19.2.3 is
“none”)
Optional 0 0 to 4 in steps
of 0.01
[channel-2 <(0 to 4
StepSize 0.01)> ]
Controls the linear delay (in
microseconds) applied to PHY
physical channel #2 of the
Downlink Data Zone.
Not relevant if dldiversity mode
(see
Section 4.8.19.2.3 is
“none”)
Optional 0 0 to 4 in steps
of 0.01
[channel-3 <(0 to 4
StepSize 0.01)> ]
Controls the linear delay (in
microseconds) applied to PHY
physical channel #3 of the
Downlink Data Zone.
Not relevant if dldiversity mode
(see
Section 4.8.19.2.3 is
“none”)
Optional 0 0 to 4 in steps
of 0.01