User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 650 System Manual
4.8.19.2.5 Configuring Airframe Linear Delay Parameters
To configure the Airframe Linear Delay parameters, run the following command:
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[channel-1 <(0 to 4
StepSize 0.01)> ]
Controls the cyclic delay (in
microseconds) applied to PHY
physical channel #1 of the
Downlink Data Zone.
Not relevant if dldiversity mode
(see
Section 4.8.19.2.3 is
“none”)
Optional 0 0 to 4 in steps
of 0.01
[channel-2 <(0 to 4
StepSize 0.01)> ]
Controls the cyclic delay (in
microseconds) applied to PHY
physical channel #2 of the
Downlink Data Zone.
Not relevant if dldiversity mode
(see
Section 4.8.19.2.3 is
“none”)
Optional 0 0 to 4 in steps
of 0.01
[channel-3 <(0 to 4
StepSize 0.01)> ]
Controls the cyclic delay (in
microseconds) applied to PHY
physical channel #3 of the
Downlink Data Zone.
Not relevant if dldiversity mode
(see
Section 4.8.19.2.3 is
“none”)
Optional 0 0 to 4 in steps
of 0.01
[channel-4 <(0 to 4
StepSize 0.01)> ]
Controls the cyclic delay (in
microseconds) applied to PHY
physical channel #4 of the
Downlink Data Zone.
Not relevant if dldiversity mode
(see
Section 4.8.19.2.3 is
“none”)
Optional 0 0 to 4 in steps
of 0.01
Command
Modes
bs airframe configuration mode