User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 649 System Manual
4.8.19.2.4 Configuring Airframe Cyclic Delay Parameters
To configure the Airframe Cyclic Delay parameters, run the following command:
npu(config-bs-66053-airframe)# cyclicdelay [channel-1 <(0 to 4 StepSize 0.01)>]
[channel-2 <(0 to 4 StepSize 0.01)>] [channel-3 <(0 to 4 StepSize 0.01)>]
[channel-4 <(0 to 4 StepSize 0.01)>]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
mode <{none |
matrixA ]>
The diversity mode used in
downlink transmissions:
None or MIMO Matrix A.
Note that the value
configured for the
dldiversity mode affects the
valid options for Cyclic
Delay (see
Section 4.8.19.2.4),
Linear Delay (see
Section 4.8.19.2.5) and
Mapping (see
Section 4.8.19.2.6)
parameters.
Optional none
 none
 matrixA
Command
Modes
bs airframe configuration mode
IMPORTANT
When creating a new BS, at least one of the Airframe Cyclic Delay parameters must be configured
explicitly (even if configured to the default value). configured.
Command
Syntax
npu(config-bs-66053-airframe)# cyclicdelay [channel-1 <(0 to 4
StepSize 0.01)> ] [channel-2 <(0 to 4 StepSize 0.01)> ] [channel-3
<(0 to 4 StepSize 0.01)> ] [channel-4 <(0 to 4 StepSize 0.01)> ]