User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 646 System Manual
4.8.19.2.2 Configuring Airframe Map Zone Parameters
To configure the Airframe Map Zone parameters, run the following command:
[segment <(0 to 2
StepSize 1)> ]
The segment (BS)
number in a three
sector BS (0-2). This
number influences
the preamble
selection and the
major group used for
the FDC
transmission.
Mandatory
when
creating a
new BS.
N/A 0 - 2
[frame-offset <(0 to
15 StepSize 1)> ]
Controls the offset
applied between the
internal frame count
and the reported
frame number
Mandatory
when
creating a
new BS.
N/A 0 - 15
[enable-ul-scrotatio
n {TRUE | FALSE} ]
Controls the uplink
sub channel rotation
functionality.
If TRUE uplink sub
channel rotation is
enabled.
Optional FALSE
 TRUE
 FALSE
[ul-dl-allocation <(3
to 7 StepSize 1)> ]
The total duration of
the uplink in a frame,
in slots. (one slot
equals 3 symbols).
The range is 4-7 for
bandwidth = 5 or
10MHz, 3-5 for
bandwidth = 7MHz.
To avoid BS-BS
interference, the
ul-dl-allocation must
be identical in all BSs
in a geographical
region.
Mandatory
when
creating a
new BS.
N/A 3 - 7
Command
Modes
bs airframe configuration mode