User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 644 System Manual
4.8.19.2 Configuring Airframe Parameters
After enabling the Airframe configuration mode you can configure the following
parameters tables:
 General (refer to Section 4.8.19.2.1)
 Map Zone (refer to Section 4.8.19.2.2)
 Downlink Diversity (refer to Section 4.8.19.2.3)
 Cyclic Delay (refer to Section 4.8.19.2.4)
 Linear Delay (refer to Section 4.8.19.2.5)
 Mapping (refer to Section 4.8.19.2.6)
 Receive (refer to Section 4.8.19.2.7)
 Uplink Feedback Zone (refer to Section 4.8.19.2.8)
 Downlink Data Zone (refer to Section 4.8.19.2.9)
 Uplink Data Zone (refer to Section 4.8.19.2.10)
 Dynamic Permutation (refer to Section 4.8.19.2.11)
4.8.19.2.1 Configuring Airframe General Parameters
To configure the Airframe General parameters, run the following command:
npu(config-bs-66053-airframe)# general [cell-id <(0 to 31 StepSize 1)>]
[preamble-grp <(1 to 2 StepSize 1)>] [segment <(0 to 2 StepSize 1)>] [frame-offset
<(0 to 15 StepSize 1)>] [enable-ul-scrotation {TRUE | FALSE}] [ul-dl-allocation <(3
to 7 StepSize 1)>]
IMPORTANT
After completing the Airframe configuration,do not forget to execute the apply command before
exiting the
Airframe configuration mode:
npu(config-bs-66053-airframe)# apply