User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 641 System Manual
Note that the valid value ranges (and in some cases also default value) of certain
parameters are affected by the value configured for the bandwidth parameter. If
you change the bandwidth, verify that these parameters are configured properly:
4.8.18.2 Displaying Configuration Information for the Baseband
Bandwidth Parameter
To display configuration information of the Baseband bandwidth parameter, run
the following command:
npu# show baseband bs [<(1 to 16777215 StepSize 1)
Specify the BS ID if you want to display information for a particular BS. For
example, to display the Baseband bandwidth of BS 66053, run the following
command:
npu# show baseband bs 66053
Do not specify this parameter if you want to view information for all existing BSs.
To display information for all BSs, run the following command:
npu# show baseband bs
Table Parameters
RF (see
Section 4.8.17.1) frequency
Airframe Structure, General (see
Section 4.8.19.2.1)
ul-dl-allocation
Airframe Structure, Map Zone (see
Section 4.8.19.2.2)
majorgrps
Airframe Structure, Uplink Feedback Zone (see
Section 4.8.19.2.8)
subchannels
Airframe Structure, Downlink Data Zone (see
Section 4.8.19.2.9)
subchannels
Airframe Structure, Uplink Data Zone (see
Section 4.8.19.2.10)
subchannels
subchannels-number
Feedback Allocation (see
Section 4.8.7.1) max-cqi
Triggers (see
Section 4.8.9.1) triggers-scnreq-rtd-max
triggers-horeq-rtd-max
Command
Syntax
npu# show baseband bs [<(1 to 16777215 StepSize 1)