User Manual

Chapter 4 - Operation and Administration Using the CLI Managing ODUs
4Motion 497 System Manual
4.6.2 Configuring ODU Ports
Up to four ODU Ports, numbered 1 to 4, can be created and configured for each
ODU. However, for a 1by1 ODU only port number 1 is meaningful. For a 2by1
ODU only ports 1 and 2 are meaningful.
1 Enable the ODU Port configuration mode for the selected ODU Port (refer to
Section 4.6.2.1)
2 You can now execute any of the following tasks:
» Configure one or more of the ODU Port parameters (refer to
Section 4.6.2.2)
» Restore the default value of the txpower-onoff parameter (refer to
Section 4.6.2.3)
3 Terminate the ODU Port configuration mode (refer to Section 4.6.2.4)
In addition, you can, at any time, display configuration and status information for
each or all of the ODU Ports (refer to Section 4.6.2.6) or delete an existing ODU
Port (refer to Section 4.6.2.5).
Display
Format
(for each
existing
ODU object
if requested
for all
ODUs)
ODUNo. :<value>
ReservedParameter1 :<value>
ReservedParameter2 :<value>
ReservedParameter3 :<value>
ReservedParameter4 :<value>
ReservedParameter5 :<value>
ReservedParameter6 :<value>
ReservedParameter7 :<value>
ReservedParameter8 :<value>
ReservedParameter9 :<value>
Command
Modes
Global command mode
To configure an ODU Port: