User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 640 System Manual
4.8.18 Managing the Baseband Bandwidth
Parameter
After enabling the BS configuration mode, you can configure the Baseband
bandwidth parameter (refer to Section 4.8.18.1).
You can display configuration information for the Baseband bandwidth parameter
of a selected or all existing BSs (refer to Section 4.8.18.2).
4.8.18.1 Configuring the Baseband Bandwidth Parameter
From the BS configuration mode, run the following command:
npu(config-bs-66053)# baseband [bandwidth {fiveMHz | tenMHz | sevenMHz}]
Command
Modes
Global command mode
To configure the Baseband bandwidth parameter:
Command
Syntax
npu(config-bs-66053)# baseband [bandwidth {fiveMHz | tenMHz |
sevenMHz} ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[bandwidth {fiveMHz |
tenMHz | sevenMHz} ]
BS channel
bandwidth
Mandatory N/A
fiveMHz
tenMHz
sevenMHz
Command
Modes
bs configuration mode
IMPORTANT
When creating a new BS, the mandatory frequency parameter must be configured.