User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 637 System Manual
In addition to the configurable parameters, the following status parameters are
also displayed:
4.8.17 Managing the RF Frequency Parameter
After enabling the BS configuration mode, you can configure the RF frequency
parameter (refer to Section 4.8.17.1).
You can display configuration information for the RF frequency parameter of a
selected or all existing BSs (refer to Section 4.8.17.2).
4.8.17.1 Configuring the RF Frequency Parameter
From the BS configuration mode, run the following command:
npu(config-bs-66053)# rf [frequency <(2302.5 to 2357.5 StepSize 0.125) |
(2498.5 to 2687.5 StepSize0.125) | (3402.5 to 3597.5 StepSize 0.125) | (3602.5 to
3797.5 StepSize 0.125)>]
Display
Format
(for each
existing BS
if requested
for all BSs)
BSIDLSB :<value>
DCDConfigurationChangeCount :<value>
RestartCount :<value>
DCDInterval(msec) :<value>
DCDTransition(frames) :<value>
Command
Modes
Global command mode
Parameter Description Possible Values
DCDConfigurationChangeCount Incremented by one (modulo 256) by the
BS whenever any of the values of the
Downlink Channel Descriptor changes.
0-255
RestartCount Iincremented by one (modulo 256)
whenever BS restarts. The value is
needed to populate neighbouring BSs
neighbour tables.
0-255
To configure the RF frequency parameter: