User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 634 System Manual
You can display configuration and status information for the DCD parameters of a
selected or all existing BSs (refer to Section 4.8.16.3).
4.8.16.1 Configuring DCD Parameters
From the BS configuration mode, run the following command:
npu(config-bs-66053)# dcd [interval <(1 to 10000 StepSize 1)>] [transition <(20 to
1000 StepSize 1)>]
To configure the DCD Parameters:
Command
Syntax
npu(config-bs-66053)# dcd [interval <(1 to 10000 StepSize 1)> ]
[transition <(20 to 1000 StepSize 1)> ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[interval <(1 to 10000
StepSize 1)> ]
The time in milliseconds
between transmission of
Downlink Channel
Descriptor messages.
Optional 1000 1 - 10000
[transition <(20 to
1000 StepSize 1)> ]
The number of frames
from the end of the frame
carrying the Downlink
Channel Descriptor
message that the BS
should wait after repeating
a Downlink Channel
Descriptor message with
an increment of the
configuration change
count before issuing a
DL-MAP message
referring to
Downlink_Burst_Profiles
Optional 100 20 - 1000