User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 633 System Manual
In addition to the configurable parameters, the following status parameter is also
displayed:
4.8.16 Managing DCD Parameters
After enabling the BS configuration mode, you can execute the following tasks:
 Configure one or more of the DCD parameters (refer to Section 4.8.16.1).
 Restore the default values of some or all of the DCD parameters (refer to
Section 4.8.16.2).
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 16777215
StepSize 1)>
The BS ID
Specify a value for this
parameter if you want to
display UCD parameters of a
specific BS. Do not specify a
value for this parameter if you
want to display UCD
parameters of all BSs.
Optional N/A 1-16777215
Display
Format
(for each
existing BS
if requested
for all BSs)
BSIDLSB :<value>
UCDConfigurationChangeCount :<value>
UCDInterval(msec) :<value>
UCDTransition(frames) :<value>
Command
Modes
Global command mode
Parameter Description Possible Values
UCDConfigurationChangeCount Incremented by one (modulo 256) by the
BS whenever any of the values of the
Uplink Channel Descriptor changes.
0-255