User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 632 System Manual
4.8.15.3 Displaying Configuration and Status Information for UCD
Parameters
To display configuration and status information of UCD parameters, run the
following command:
npu# show ucd bs [<(1 to 16777215 StepSize 1)
Specify the BS ID if you want to display information for a particular BS. For
example, to display the UCD parameters of BS 66053, run the following
command:
npu# show ucd bs 66053
Do not specify this parameter if you want to view information for all existing BSs.
To display information for all BSs, run the following command:
npu# show ucd bs
Command
Syntax
npu(config-bs-66053)# no ucd [interval ] [transition ]
Privilege
Level
10
Command
Modes
bs configuration mode
Command
Syntax
npu# show ucd bs [<(1 to 16777215 StepSize 1)
Privilege
Level
1