User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 630 System Manual
 Configure one or more of the UCD parameters (refer to Section 4.8.15.1).
 Restore the default values of some or all of the UCD parameters (refer to
Section 4.8.15.2).
You can display configuration and status information for the UCD parameters of a
selected or all existing BSs (refer to Section 4.8.15.3).
4.8.15.1 Configuring UCD Parameters
From the BS configuration mode, run the following command:
npu(config-bs-66053)# ucd [interval <(1 to 10000 StepSize 1)>] [transition <(20 to
1000 StepSize 1)>]
To configure the UCD Parameters:
Command
Syntax
npu(config-bs-66053)# ucd [interval <(1 to 10000 StepSize 1)> ]
[transition <(20 to 1000 StepSize 1)> ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[interval <(1 to 10000
StepSize 1)> ]
The time in milliseconds
between transmission of
Uplink Channel Descriptor
messages.
Optional 1000 1 - 10000