User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 618 System Manual
4.8.14.3.3 Restoring the Default Values of Neighbor BS Trigger Setup Parameters
To restore some or all of the Neighbor BS Trigger Setup parameters to their default
values, run the following command:
npu(config-bs-66053-nbr-68000)# no triggersetup [hysteresismargin]
[timetotrigger] [avgduration-rssi] [avgduration-cinr] [avgduration-rtd]
You can restore only some parameters to their default values by specifying only
those parameters. For example, to restore only the hysteresismargin parameter to
the default value, run the following command:
npu(config-bs-66053-nbr-68000)# no triggersetup hysteresismargin
This parameter will be restored to its default value, while the other parameters
will remain unchanged.
To restore all Neighbor BS Trigger Setup parameters to their default value, run the
following command:
npu(config-bs-66053-nbr-68000)# no triggersetup
Privilege
Level
10
Command
Modes
bs neighbour bs configuration mode
NOTE
Refer to Section 4.8.14.2.3 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-nbr-68000)# no triggersetup [hysteresismargin ]
[timetotrigger ] [avgduration-rssi] [avgduration-cinr]
[avgduration-rtd ]
Privilege
Level
10
Command
Modes
bs neighbour bs configuration mode