User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 616 System Manual
4.8.14.3 Restoring Default Values for Neighbor BS Configuration
Parameters
After enabling the Neighbor BS configuration mode you can restore the default
values for non-mandatory parameters in the following parameters tables:
 General (refer to Section 4.8.14.3.1)
 Required C/N Level (refer to Section 4.8.14.3.2)
 Trigger Setup (refer to Section 4.8.14.3.3)
4.8.14.3.1 Restoring the Default Values of Neighbor BS General Parameters
To restore one or all of the Neighbor BS non-mandatory General parameters to
their default values, run the following command:
npu(config-bs-66053-nbr-68000)# no general [syncind] [srvcsupport]
[eirx-pir-max]
You can restore only some parameters to the default values by specifying only
those parameters. For example, to restore only the syncind to the default value,
run the following command:
npu(config-bs-66053-nbr-68000)# no general syncind
The parameter will be restored to its default value, while the other parameters will
remain unchanged.
To restore all non-mandatory parameters to their default value, run the following
command:
npu(config-bs-66053-nbr-68000)# no general
<trigger-name> The Trigger name. Mandatory N/A See
Table 4-3
0
<trigger-value> Defines the threshold
value for the Trigger.
Mandatory N/A See
Table 4-3
0
Command
Modes
bs neighbour bs configuration mode