User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 607 System Manual
If you use this command to create a new Neighbour BS, the configuration mode
for this Neighbour BS is automatically enabled, after which you can execute any
of the following tasks:
 Configure one or more of the parameters tables of the Neighbour BS (refer to
Section 4.8.14.2)
 Restore the default values of parameters in one or more of the parameters
tables of the Neighbour BS (refer to Section 4.8.14.3)
After executing the above tasks, you can terminate the Neighbour BS
configuration mode (refer to Section 4.8.14.4) and return to the BS configuration
mode.
Note that for properly completing the configuration of a Neighbour BS the apply
command must be executed prior to exiting the Neighbour BS configuration mode.
For example, to define Neighbor BS 66055 for bs-68000, run the following
command:
npu(config-bs-66053)# nbr 68000
Command
Syntax
npu(config-bs-66053)# nbr <(1 to 16777215 StepSize 1)>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
nbr <(1 to 16777215
StepSize 1)>
The BS ID (BSIDLSB) of the
Neighbour BS
Mandatory 1 - 16777215
Command
Modes
bs configuration mode
NOTE
The following examples are for Neighbour BS configuration mode for bs-66053, neighbour bs (nbr)
68000.